SPONSORS
2024 ICRBE EXPO |
guidebrod rod finish
Posted by:
bill hartlage
(---.proxy.aol.com)
Date: November 15, 2005 05:45PM
I have used flex coat regular , which was ok, lite ,which I had problems with, and I am wondering about the guidebrod products. any input appreciated. Re: guidebrod rod finish
Posted by:
Mike Barkley
(---.nap.wideopenwest.com)
Date: November 15, 2005 07:14PM
I haven't used Gudebrod nor know anyone that has but I would like to mention that ALL finishes do what they are supposed to do and work pretty well but they all have their own characteristics and each has a learning curve. Finish problems are generally due to the way it is applied.
What problems have you been having? If you have problems with one, you will probably have problems with another. The trick is to perfect a method than stick with it until you get consistant results> Mike Re: guidebrod rod finish
Posted by:
Trevor Doylend
(---.gv.shawcable.net)
Date: November 15, 2005 08:01PM
I've used the gudebrod finish, it works well but in all cases it has left a oil like swirl in the final product. Didn't matter how much I mixed it, it still came out swirly. Re: guidebrod rod finish
Posted by:
rusty berrier
(---.nclxtn.infoave.net)
Date: November 15, 2005 10:19PM
I've used the gudebrod finishes without problem-seemed to set up hard a little faster than flexcoat-kinda threw me off when i mixed it and it looked slighty blue-green but cured out colorless-at least as near as i could tell on the blue wraps I was doing. Re: guidebrod rod finish
Posted by:
Pavel Novolokin
(---.pppoe.mtu-net.ru)
Date: November 16, 2005 01:04PM
Now I use Gudebrod Regular. Comparing to FC Lite I used before, it takes a little more time to set up but gives some more time to work as well Pavel, Moscow, RU Sorry, only registered users may post in this forum.
|