SPONSORS
2024 ICRBE EXPO |
3.5 tip top
Posted by:
John Kepka
(---.iad.untd.com)
Date: October 01, 2005 05:30PM
I am building a dan craft 3 wt which needs a 3.5 tip top--of course i don't have one handy. I am look ing for some suggestions on which to use and a possible sponsor source. the guide will be recoil.
thanks John God bless the troops and USA Re: 3.5 tip top
Posted by:
Bob Crook
(---.onspeed.com)
Date: October 01, 2005 06:10PM
Dan should be able to get you one, Baston has 3.5 standard loop tip tops in their catalog and Dan Is a Baston dealer. Re: 3.5 tip top
Posted by:
Shawn Moore
(82.96.100.---)
Date: October 01, 2005 07:50PM
Use a single foot guilde wrapped on at the tip of the blank. Works great! Re: 3.5 tip top
Posted by:
Mike Leary
(---.hsd1.ca.comcast.net)
Date: October 01, 2005 08:02PM
If you want Recoil, Dan lists them as one of his suppliers in his catalog and Recoil does make a 3.5 tip-top in a small loop design. You might also try to order direct from REC as they are a sponsor and I have had good service from them in the past. Actually, they are the reason I found this site in the first place.
Could the moderator of this site remove the name of Lynn Leary and email of lleary00@hotmail.com as I have tried, unsuccessfully, to log on many times and it will not allow it. I have tried a false name and it was just deleted eventhough I requested some assistance and had stated the problem. I never got the welcome e-mail and have never been able to log on or post. The first name used in this post is my middle name so I hope I have not broken any of the boards rules and I am again respectfully requesting some assistance. Thank You Lynn Re: 3.5 tip top
Posted by:
Anonymous User
(Moderator)
Date: October 01, 2005 08:10PM
A confirmation email was sent to you. You will have to disable your spam or junk mail filter to allow it to make it through to you. All I can do is send the confirmation, you have to allow it to make it through to you.
............... Re: 3.5 tip top
Posted by:
Mike Leary
(---.hsd1.ca.comcast.net)
Date: October 01, 2005 08:35PM
Thanks for the reply! Sorry, only registered users may post in this forum.
|