SPONSORS
2024 ICRBE EXPO |
Spine on Sig V help
Posted by:
Daniel Rees
(---.l6.c4.dsl.pol.co.uk)
Date: October 01, 2005 07:09AM
Just recieved my 905-3 sig V Dan Craft which has arrived with white china pen marks on the ferule ends. Tried spining the blank seems to have two spines. Also if I put the marks on the outside curve of the blank, the blank seems to want to twist out of this position slightly, probably around 30 degrees as a guess.
I'm a little bit stuck with what to do next. Should I place the guides on the side thats been marked, the outside of the curve as I find it, the outside of the other curve that the blank wants to rotate too, or somewhere else?! Help!! Daniel Re: Spine on Sig V help
Posted by:
bill boettcher
(---.250.150.226.Dial1.Weehawken1.Level3.net)
Date: October 01, 2005 07:25AM
Call or email Dan. He will explaine it to you.
This may also help [www.rodbuilding.org] Edited 1 time(s). Last edit at 10/01/2005 07:31AM by bill boettcher. Sorry, only registered users may post in this forum.
|