SPONSORS
2024 ICRBE EXPO |
American Tackle please respond.....
Posted by:
Duane Richards
(---.rn.hr.cox.net)
Date: August 26, 2005 07:50PM
I have built an AESJ783 blank and need the factory decal for this series. I have all documentation and paperwork from Bingham where it was purchased. Please contact me at email below.
THANK you!! (sorry I had to "board it" but I couldn't get the email on your site to function) drcrwr@yahoo.com DR Re: American Tackle please respond.....
Posted by:
Anonymous User
(Moderator)
Date: August 26, 2005 08:03PM
There is no guarantee that anyone from American Tackle will see your post here. Please keep that in mind. I'm sure that Joe and Darrin look in when they can, but your best bet is always to try to contact them directly. You can do a search on this site for either and use those email addresses, or use the one on their site and manually enter it into your email program.
............ Re: American Tackle please respond.....
Posted by:
eric zamora
(216.101.134.---)
Date: August 26, 2005 08:07PM
if you go to american tackle's web site and click on the link About Us, you'll find two sets of contact information including phone numbers. it seems to me calling should always be the first avenue of communication in this type of situation if time is of the essence.
eric fresno, ca. Re: American Tackle please respond.....
Posted by:
Randy Parpart (Putter)
(---.propel.com)
Date: August 27, 2005 12:53AM
info@AmericanTackle.US
I clicked on their "email" banner on the left side of their opening web page and got the above address??? Re: American Tackle please respond.....
Posted by:
bill boettcher
(---.250.162.2.Dial1.Weehawken1.Level3.net)
Date: August 27, 2005 09:51AM
Since you have the paper work maybe Decal Connection can help you out. Re: American Tackle please respond.....
Posted by:
Duane Richards
(---.rn.hr.cox.net)
Date: August 27, 2005 05:56PM
Thanks guys, I believe it's handled.
I don't know why I couldn't get their email addy.....grimlins maybe :) I appreciate all the help! DR Sorry, only registered users may post in this forum.
|