SPONSORS
2024 ICRBE EXPO |
ROD TIP SIZE??
Posted by:
Michael Friddle
(---.triad.res.rr.com)
Date: August 06, 2005 02:22PM
If I have a stand-up rod with a size 10 tip but can't find an 10 with a large enough opening like I like can I take and build the tip up to fit a size 12?? Re: ROD TIP SIZE??
Posted by:
Lou Reyna
(---.hr.hr.cox.net)
Date: August 06, 2005 02:48PM
In the past I have built up tip diameters with two narrow bands of thread with good results -. If doing it this way concerns you then use a sleeve made from a piece of scrap blank and bond it to the blank tip with paste epoxy, then grind down the new diameter if too large. Both ways have worked for me.
Lou Sorry, only registered users may post in this forum.
|