SPONSORS
2024 ICRBE EXPO |
30 lb Trolling travel rod
Posted by:
Daniel Rotea
(---.proxycache.rima-tde.net)
Date: July 17, 2005 01:36PM
Dear friends,
Although I've been busy these last weeks, I've build a couple of rods. I'll post pics in the photo section tomorrow. On of these was a 5'6" 30lb trolling rod, built from a Seeker 655 blank. I used Afto lightweight rollers and the result was not bad. One of my friends liked it and he asked me to buitd a couple of rods like this one, but in 3 pieces. I haven't found such a blank in the catalogs I have. Can any one advice me about this?. If not possible, I'd propose a 2 pieces rod. I've seen some Shimano travel rod in 3 pieces, with graphite ferrules. The idea is building something similar. Any idea will be welcomed. Regards, Daniel Edited 1 time(s). Last edit at 07/17/2005 06:26PM by Daniel Rotea. Re: 30 lb Trolling travel rod
Posted by:
Al Johnson
(---.dyn.optonline.net)
Date: July 18, 2005 05:59AM
Dont know if they make multi piece trolling rods but what I have mad is 5'6" stand up rod with aftco or pacbay unibutts. This wasy you can break the rod down a little bit. Sorry, only registered users may post in this forum.
|