SPONSORS
2024 ICRBE EXPO |
wrapping question
Posted by:
Harald Runde
(---.bb.online.no)
Date: June 03, 2005 07:18PM
There is a small contour showing from the underlaying thread that is inserted into the wraps by the pull-through loop. Will this still be showing after epoxy is applied? Do you manipulate the thread in some way to avoid this contour?
Thanks! Harald Re: wrapping question
Posted by:
Anonymous User
(---.proxy.aol.com)
Date: June 03, 2005 08:35PM
Your tension may be slightly loose. That little dimple you see can be easily straightened out by a packing tools. I use one of the plastic thread tools that are available from the board suppliers. It is nice to get this edge straight before you apply finish. Your will have less trouble getting a fine clean edge overlap on the finish.
Gon Fishn Sorry, only registered users may post in this forum.
|