SPONSORS
2024 ICRBE EXPO |
rod dryer motor
Posted by:
Jim Catrona
(---.pitt.east.verizon.net)
Date: March 07, 2005 09:52PM
I noticed that in the Mud Hole catalog that they carry a 9 rpm motor used for drying. Can this be rigged on homemade base & wired for use or is it specifically to be use with a manufacturers power wrapper? It's cost is right at $6.00. Any replies or other suggestions are welcome. Re: rod dryer motor
Posted by:
Stan Gregory
(---.mynetrocks.com)
Date: March 07, 2005 10:01PM
Yes, just wire it to an off-on switch on the "hot" side of the wiring. At least this is how I've done it.
Stan Re: rod dryer motor
Posted by:
Jim Catrona
(---.pitt.east.verizon.net)
Date: March 07, 2005 10:39PM
Thanks for the quick response Stan. Sorry, only registered users may post in this forum.
|