SPONSORS
2024 ICRBE EXPO |
thread color suggestion
Posted by:
Ken Yorke
(---.dyn.optonline.net)
Date: March 05, 2005 02:34PM
I am going to build a T&T horizon series 9wt (dark navy blue blank) and was looking for some suggestions for thread color. I was thinking a chestnut brown might look good but would like some other ideas. Re: thread color suggestion
Posted by:
Jim Crisci
(68.114.45.---)
Date: March 05, 2005 03:18PM
Ken,
I just finished a Forecast, 4 pc 5wt. The blank is a beautiful dark blue. I used Gudebrod garnet with no CP and tipped the wraps in gold HT metallic. The results are very nice. The garnet wraps look like jewels against the blank. Silver metallic would have been nice as well. I remember reading about this color combination on the board here and the advice was, as usual, right on the money. Good luck on the project. Re: thread color suggestion
Posted by:
Doug Moore
(---.dfw.dsl-w.verizon.net)
Date: March 05, 2005 04:38PM
Colors/Shades of browns trimmed in red/gold. Colors/Shades of red trimmed in gold/yellow. Regards......Doug@ TCRds Re: thread color suggestion
Posted by:
Milton (Hank) Aldridge
(---.maine.res.rr.com)
Date: March 05, 2005 06:09PM
Ken,
Garnett with teal trim wraps no CP - Look very sharp over dark blue Hank On The Rocks Fishing Wells, ME. Re: thread color suggestion
Posted by:
Joel Todd
(---.nas32.chicago3.il.us.da.qwest.net)
Date: March 05, 2005 06:58PM
Colbalt Blue trimmed with Goldenrod.I used this on a Matte blank but it might work ok on the dark Blue as well. Sorry, only registered users may post in this forum.
|