SPONSORS
2024 ICRBE EXPO |
UL Tip top
Posted by:
Thomas Schell
(---.printrainbow.com)
Date: February 22, 2005 02:59PM
I have an UL blank with a tip size of 4. The tip top that I want to use only goes as small as a 5 opening. Is this ok? can i just fill up the dead space with epoxy and then cover over with a thread wrap? Re: UL Tip top
Posted by:
Ralph D. Jones
(---.att.net)
Date: February 22, 2005 04:38PM
Thomas, you can wrap the tip of the blank with A thread, seal the thread with 5-min. epoxy, then put on the tip top. Or you can use the size guide next to the tip for a tip guide. Remember to use a security wrap. Ralph If at first you don't succeed, go fishing, then try, try again. Sorry, only registered users may post in this forum.
|