SPONSORS
2024 ICRBE EXPO |
Breakaway 1145/2
Posted by:
gary campo
(---.dyn.optonline.net)
Date: January 15, 2005 09:30PM
Picked up my first breakaway blank. I searched but found nothing about the 1145/2. It seems that the stripper guide [40 HH] will sit right on top of the ferrule. Is that ok [never built a 2 piece before]. Also would 5 guides be enough for this rod [spinning configuration]. Thanks for any advice. Re: Breakaway 1145/2
Posted by:
Randy Parpart (Putter)
(---.nccray.com)
Date: January 15, 2005 09:33PM
I do about everything that I can to place a guide on the ferrule when building a 2 piece.
Putter Re: Breakaway 1145/2
Posted by:
Bil Gburek
(---.cac.psu.edu)
Date: January 15, 2005 11:15PM
Gary,
Apologies for hijacking your message, but Putter, I'm wondering why you "do about everything" to get a guide on the ferrule? Bilgee Re: Breakaway 1145/2
Posted by:
Randy Parpart (Putter)
(---.nccray.com)
Date: January 15, 2005 11:28PM
I have to wrap the ferrule anyway, so why not?? I deal with one piece or two piece walleye rods. If I can get the guide on the ferrule on those two piece, I do it. If I can't, I don't. But it's very rare when I can't.
Putter Edited 1 time(s). Last edit at 01/15/2005 11:37PM by Randy Parpart (Putter). Re: Breakaway 1145/2
Posted by:
Joe Rivera
(---.ca.charter.com)
Date: January 16, 2005 02:00AM
If you don't find what you need here (unlikely) you might also post the question on the rod building forum on
www.stripersonline.com I'm building on the same Blank and Found some good Info there. Good Luck Joe Re: Breakaway 1145/2
Posted by:
Jud Tussing
(---.wma.east.verizon.net)
Date: January 16, 2005 01:44PM
I've built on that blank myself. I put the first guide just before the ferrule and I'll tell you why. Eveny high quaslity 2-piece blanks will turn a little bit during a day of casting (and the loads that blank can carry will onlyt exagerate that problem. By placing a guide on the first section I think the rod shown a tendancy to turn a bit less. Good luck. Sorry, only registered users may post in this forum.
|