SPONSORS
2024 ICRBE EXPO |
6 Sided Chevron 2
Posted by:
Dale Cecil
(---.proxy.aol.com)
Date: January 03, 2005 08:10PM
Should have been more specific. Bruce from Rod components of south Fl.
had a layout of 2 inch and 1 inch spacing that made it really easy but I can not remember it for anything Re: 6 Sided Chevron 2
Posted by:
Danny Bundy
(---.69-93-60.reverse.theplanet.com)
Date: January 03, 2005 08:14PM
Forgive me for being dense, but would you just work on 6 axis's instead of 2? Instead of 0 and 180 just go every 60 degrees and its opposite? Re: 6 Sided Chevron 2
Posted by:
Ken Preston
(---.longhl01.md.comcast.net)
Date: January 03, 2005 10:02PM
Dale,
I think you lost me... The layout (spacing) will vary proportionally with the diameter of the blank. I can't think of how a " 2 inch and 1 inch spacing " would work - especially on a 6-axis wrap. Pretty complicated stuff (at least to me). Again I think the starting points for the 6-axis wrap are 30,60,120 // 210, 240, 300 (equal reciprocals to the initial even spacing) So one thread starts at 30 and the cross-over (companion thread starts at 210)... I think ... or maybe I'm making this harder than it seems?? Maybe Billy V, Mark Crouse or one of the other folks can help more. Sorry, only registered users may post in this forum.
|