SPONSORS
2024 ICRBE EXPO |
Need to etch between coats?
Posted by:
Elrod (Jon Jenkins)
(---.brns.cox-internet.com)
Date: December 29, 2004 03:14PM
OK, it's been a while. had to tear down and move and other things, so haven't been building in a while. I remember the topic from a while back, but I put a coat of finish on prior to feather inlay. It has been about 5 days and going to work on the inlay tonight. If the LS is completely cured do I need to sand or etch the existing coat before applying more coats? Couldn't remember from the past if that needs to be done for proper adhesion if the finish has been cured for more than X many days.
Thanks Re: Need to etch between coats?
Posted by:
bill boettcher
(---.248.70.87.Dial1.Weehawken1.Level3.net)
Date: December 29, 2004 03:35PM
Yes. Usually after 2-3 days you should scoff with a fine pad in order to get the next coat to stick well. There is an artical in the libary page that explans this well. Plus other articals with good content Sorry, only registered users may post in this forum.
|