SPONSORS
2024 ICRBE EXPO |
Small zip ties
Posted by:
John Carlton
(---.bc.dl.cox.net)
Date: December 13, 2004 11:06PM
Never posted here but i build rods for a living. Just wanted to share a little trick i learned on my own. I use small zip ties to hold my guides in place. To me i just works better than tape our tubeing. Re: Small zip ties
Posted by:
Noel Spann
(12.39.180.---)
Date: December 13, 2004 11:21PM
John, I do the same. I never did like using tape. Noel Re: Small zip ties
Posted by:
Myles Boon
(202.138.16.---)
Date: December 13, 2004 11:59PM
Welcome on board John, I hope you stay around and keep posting. Myles Brisbane, Australia Re: Small zip ties
Posted by:
larry pirrone
(---.ontrca.adelphia.net)
Date: December 14, 2004 12:00AM
yep. same thing. works great. Re: Small zip ties
Posted by:
Fred Murphy
(---.stkn.mdsg-pacwest.com)
Date: December 14, 2004 12:47AM
I've been using the tubing, but think I'l try the zip ties next time. Welcome to the board, John. Murf/kokehead Re: Small zip ties
Posted by:
bill boettcher
(---.250.111.12.Dial1.Weehawken1.Level3.net)
Date: December 14, 2004 08:02AM
Rubber bands tied onto the blank work for me Re: Small zip ties
Posted by:
Rob Grider.
(---.digitalgroup.net)
Date: December 14, 2004 12:50PM
What do you use to cut the zip ties? Always willing to try something different but the small ties that I have used are rather tough to cut unless using snips and I would be afraid to use those around my blank with my clumsy hands. Re: Small zip ties
Posted by:
larry pirrone
(---.los-angeles-61-63rs.ca.dial-access.att.net)
Date: December 14, 2004 01:44PM
ROB, i use a pair of diagonal cutting pliers. i cut the little block where the ties go together. the zip tie just pops off. i have never hurt a blank this way. if you cut with the jaws perpendicular to the blank the cutting process will not tighten the tie (which could put pressure on the blank) and it just pops off. try this on a scrap and you will see what i mean. you want to use nice sharp "dikes" and it will slice right through the tie junction block with little effort. Re: Small zip ties
Posted by:
John Dow
(---.port127.snet.net)
Date: December 14, 2004 09:17PM
The zip ties are good on the bigger blanks , but I've become a fan of the Flex Coat guide adheasive as of late for the smaller fly rod single foot guides. John Re: Small zip ties
Posted by:
Domenic Federico
(---.as0.wlgh.oh.core.com)
Date: December 15, 2004 10:24AM
John- When using the flex coat guide adhesive, are you able to reposition the guide after you get a few wraps up the foot? Or is it imperative to get the alignment straight out of the gate? Thanks, Domenic Sorry, only registered users may post in this forum.
|