SPONSORS
2024 ICRBE EXPO |
Blank question
Posted by:
Trevor Doylend
(---.gv.shawcable.net)
Date: December 09, 2004 10:49PM
When you buy a lets say,a Sage blank, is the logo/line wt already on the blank or does it have to be applied by the builder? Re: Blank question
Posted by:
Mick McComesky
(---.nas3.saint-louis1.mo.us.da.qwest.net)
Date: December 09, 2004 11:12PM
All the name brand rods I do have the company logo and blank info on a separate decal for the builder to apply. St. Croix has a decal down on the butt which is covered by the grip eventually but they also supply a separate decal. Never built a Sage though so I can't speak for them specifically. Re: Blank question
Posted by:
Chuck McIntyre
(---.228.120.165.Dial1.Denver1.Level3.net)
Date: December 09, 2004 11:45PM
The Sage blanks I have built on have always been printed. The location is generally in the same location as on their factory rods. Re: Blank question
Posted by:
Bill Moschler
(---.ag.utk.edu)
Date: December 10, 2004 07:56AM
Sage is printed. And it is different from a finished sage rod in that it ends in B for blank. Winston is plain. Sticker that says Winston. Their info othe than that is hand written on finished rods, not on blank. St. Croix-plain with sticker. Lamiglas-plain with sticker. Diamondback-just the name. Loomis-plain with sticker Actually sage is the only blank I have seen with complete info. Re: Blank question
Posted by:
Bryan Yee
(---.sd131.k12.id.us)
Date: December 10, 2004 01:56PM
G-Loomis IMX blanks are blank. Ha Ha Ha. Sorry, only registered users may post in this forum.
|