SPONSORS
2024 ICRBE EXPO |
Plugging blank end ....... ?
Posted by:
Mal. Marlow
(---.sympatico.ca)
Date: December 04, 2004 09:34AM Is there an easy way plugging the hole in the male end of a blank - instead of making plugs to fit the inside dia. of the blank. Just wondered if a rubber based or similar compound would do the job satifactory....... ! Many thanks, Mal. Re: Plugging blank end ....... ?
Posted by:
Marcel Charest
(---.agstme.adelphia.net)
Date: December 04, 2004 09:59AM
Mal, Yes i use rod bond. hope this helps Marcel Re: Plugging blank end ....... ?
Posted by:
Ralph Jones
(---.att.net)
Date: December 04, 2004 10:10AM
In the past I have used small bottle corks held in by epoxy but I now agree, Rod Bond except when I want the contrast of the cork. Ralph Re: Plugging blank end ....... ?
Posted by:
Michael Sledden
(208.21.98.---)
Date: December 04, 2004 10:47AM
When I was up at the St Croix factory a few month ago, all they did was use a colored epoxy that matched the color of the blank. Re: Plugging blank end ....... ?
Posted by:
Mal. Marlow
(---.sympatico.ca)
Date: December 05, 2004 09:51AM
Thanks for your replies - too many choices.......... ! I did'nt realise there were so many alternatives to plugging the male end of a blank. Thanks again everyone. Mal. Sorry, only registered users may post in this forum.
|