SPONSORS
2024 ICRBE EXPO |
Lamiglas
Posted by:
Lanny De Rose
(---.proxy.aol.com)
Date: November 06, 2004 03:50PM
Hello: I posted a note on 10/31/04 regarding my Lamiglas 9' 3 piece 4/5 wt. Perigee rod and how it broke the first the cast it. First, thank you to all the fellow rod assemblers who responded. Second. The next day, Todd Vivian of Lamigas responded to my post and was really nice and stated Lamiglas would replace the tip section ASAP. I think that the chief rod designer form a major rod company like Lamiglas responding to average joe rod assembler like me is awsome. Thank you to all. Lanny Re: Lamiglas
Posted by:
Bob Maulucci
(---.bflony.adelphia.net)
Date: November 06, 2004 04:10PM
That is the same treatment I received. Great service. Bob Maulucci Re: Lamiglas
Posted by:
Coach Paul Bagby
(---.82.102.166.ip.alltel.net)
Date: November 06, 2004 09:13PM
Class act there. I got same results when I had a question about a blank. Re: Lamiglas
Posted by:
Mike Williams
(---.ipt.aol.com)
Date: November 06, 2004 09:25PM
I think most blank and components companies watch this board pretty close. Even those that aren't sponsors like Lamiglass. They know the traffic this place gets and the numbers of builders who use it for info. If I were running a blank or component company this is one place I'd pay attention to. It would help you keep your pulse on what's going on in the trenches of rod building. Post Removed
Posted by:
Kerry Hansen
(---.proxy.aol.com)
Date: November 07, 2004 09:03PM
Post Removed - invalid e-mail address Re: Lamiglas
Posted by:
Steve Satterfield
(---.proxy.aol.com)
Date: November 08, 2004 09:16PM
Todd and Lamiglas have gone out of there way many times for me and my friends. They always seem to have the answers for my questions. Steve Sorry, only registered users may post in this forum.
|