SPONSORS
2024 ICRBE EXPO |
epoxy
Posted by:
ron flynn
(216.119.50.---)
Date: February 18, 2002 08:24PM
what would be the best epoxy when fitting a tuff butt sleeve to an eva foam grip or a cork grip? thanks Re: epoxy
Posted by:
Frank Thramer
(---.proxy.aol.com)
Date: February 18, 2002 08:35PM
Most any two-part slow cure epoxy or the U40 Rodbond would be good I would think. Make sure you clean the inside of the tuff butt with alcohol and then scuff it good with scotchbrite though. Sorry, only registered users may post in this forum.
|