SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 4 of 4
4 months ago
Bruce Tarbet
Finally I've had the opportunity to put this technique to work. To establish the weights, I measured several batches of 3cc resin/catalyst portions by syringe and recorded the weight in grams. The mixing pot weight was zeroed out before weighing the epoxy. For several more batches, I placed the mixing pot on the scale and zeroed the tare, then added each component to the needed weight was achieve
Forum: rodboard 1 year ago
Bruce Tarbet
There would definitely need to be some research as to the density of each, but it shouldn't be too hard. I'd start with separately weighing 3 ml of resin and 3 ml of hardener and recording those amounts. I feel that would be no less accurate than the sometimes messy syringe systems. I'm curious enough to give it a try and will report back my results.
Forum: rodboard 1 year ago
Bruce Tarbet
Greetings.
As I was mixing my last batch of thread epoxy and fussing with air bubbles in the syringe I wondered if would be easier to measure out the epoxy by weight? With a small scale it seems that adding each part to a mixing dish would eliminate the whole syringe and air bubble issue. A little practice would be needed to get the right weight per milliliter, but that's easy enough to do.
Forum: rodboard
Current Page: 1 of 1
|