SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 11 of 11
2 years ago
Taso hountas
First off, you all are fantastic thank you for the information. I put it all together and measured out to be about 1/4 inch longer than 9ft. Never accounted for the ferrules over lap.. I am definitely doing a static test before epoxy just wanted a starting point.
As for guides I went with snake brand snake guides From the tip top the first 4 are 1/0 light wire 5 and 6 are sz 1 lig
Forum: rodboard 2 years ago
Taso hountas
Thanks for the reply…. It is only for the first 3 sections of a 4 piece when I get back home I will measure each section
Forum: rodboard 2 years ago
Taso hountas
Hi all
I was about to lay out the guide spacing on the first 3 sections put together. I noticed the cts is about 1 inch longer than my other 9ft blanks for the same sections is that something I need to worry about? It is my first fly rod build. I was going to use the sage x 9ft 4wt spacing listed on the sage website .. any advice is greatly appreciated
Forum: rodboard 4 years ago
Taso hountas
Guys,
Thank you for all the suggestions.. from my limited knowledge I think you all covered the issues I may have.
Forum: rodboard 4 years ago
Taso hountas
Hi Mark,
Thanks for your insight. Was thinking that in case I could not find something. One suggestion I received was to use the batson fbwc and from what I saw on line it seems to be what I am looking for.
Forum: rodboard 4 years ago
Taso hountas
Hey....
I am looking for advise, I am building a rod and will use the Fuji pts reelseat with hidden thread.
My question is....
what would be the best way to seal the gap in the front between the barrel and blank. Would a winding check work?
Forum: rodboard 4 years ago
Taso hountas
Hi,
Thanks for the reply, the location on the blank were I am planning to put the seat is between 10.5 and 11 mm depending on how long I want the handle. So I am trying to avoid the exposed blank route.
Forum: rodboard 4 years ago
Taso hountas
Hi everyone,
I searched and could not find any info.
I am building a black hole b-661hmf (first non fly rod build). And I am looking for reel seat recommendations.
I looked at the Fuji ACSM seats and they are too smalll for the Avet sxj that I will be using.
I also looked at the Fuji pts series, but I am having an issue with the insert. Ordered 2 and both won’t fit.
I have rea
Forum: rodboard
Current Page: 1 of 1
|