SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 5 of 5
4 years ago
Justin Ile
Hey Bert,
Thanks for the offer. I am located in PA. I purchased a new piece from mudhole yesterday. I am going to attempt the drill idea this weekend. seems easy enough, but If this fails i may be in contact hahaha.Thanks again everyone!
Forum: rodboard 4 years ago
Justin Ile
Thanks for the reply Bert, But unfortunately, i do not have a lathe to form these down. But that is the exact grip i want.
Forum: rodboard 4 years ago
Justin Ile
Any ideas where I could by a Blue Camo EVA 6 inch rear and 5 inch front grip. I do not have a lathe.... I have spent hours searching the internet, pre made ones just don't seem to exist. would like the inside diameter to be 3/8.
Thanks,
Justin
Forum: rodboard 4 years ago
Justin Ile
Thanks everyone for the replies! A lot of great information!!
Forum: rodboard 4 years ago
Justin Ile
Hello everyone, i am new to the site and rod building. I am looking to build a smaller float rod for some smaller PA trout streams. Currently i have been using a 8 foot crappie rod with my pin. I love the length, but the rod just dont have enough power for bigger trout. I was thinking about using an 8 foot 4 wt rod blank and putting spinning guides on it. Could anyone suggest any blanks and guide
Forum: rodboard
Current Page: 1 of 1
|