SPONSORS
2024 ICRBE EXPO |
Current Page: 1 of 1
Results 1 - 7 of 7
4 years ago
Ryan Janos
Stint it is! I found a carbon tube that is hollow but has a thick wall. Does anyone think a solid stint is required? Thanks again.
Forum: rodboard 4 years ago
Ryan Janos
Phil, I'm starting from scratch so whatever hardware/insert combo might come off the shelf with an ID large enough to fit the 0.455" butt diameter.
Forum: rodboard 4 years ago
Ryan Janos
Phil, I was trying to use a rat tail file and it was taking forever so I chamferred the lip and started boring it out with a hand drill. I made it about halfway before it blew up.... Did the same thing twice because I got sick of filing twice. Thought if I was careful it would work out. Not so much.
I had already glued up the hardware a while back as these were extra parts laying around. I'm t
Forum: rodboard 4 years ago
Ryan Janos
This past weekend I busted two inserts trying to increase the ID to fit a 5wt fiberglass blank.The butt is 0.455" and I'm having trouble finding a prefab insert that would fit this. Can anyone suggest a part? I'd prefer a natural wood insert. Thank you.
FYI I don't have a drill press or lathe so the breaking was 100% my fault.
Ryan
Forum: rodboard 5 years ago
Ryan Janos
I just finished a Rainshadow RX6 8wt for stripers in the Sacramento Delta. It's not like you need to bomb huge casts to these fish so the moderate action actually makes a day of fishing from the boat a bit more relaxing. I was able to throw a 300 grain 30' head into the wind about 70' without any false casting and I'm an average caster. Sure, a rod with a faster tip wouldn't hurt... but it might
Forum: rodboard 5 years ago
Ryan Janos
Phil Erickson Wrote:
-------------------------------------------------------
> I likely repeat much of what you got above, but
> here goes.
>
> All models of the Rainshadow line are excellent
> quality and very reliable! The model selection
> depends upon your application and budget. The "F"
> series is the low end cost wise and the most
> moderate acti
Forum: rodboard
Current Page: 1 of 1
|