SPONSORS
2024 ICRBE EXPO |
Rod Crafters Journal
Posted by:
Rick Warren
(---.wcnet.org)
Date: October 03, 2003 06:46PM
I got these Rod Crafters Journal magazines when I purchased a Renzetti Lathe and an assortment of rod building supplies from a gentleman in the Detriot, Mi. area. They are from March 1975 to Dec. 1986. There are about 75 or 80 issues. Are they of any value ? Also I am looking for Dale Clemens weaving tool that is used in the Decorative Rod Wrapping Volume 2 Video by Artie Herbert. I can not seem to locate one on the internet. Re: Rod Crafters Journal
Posted by:
Ed Sabatini
(---.proxy.aol.com)
Date: October 03, 2003 08:19PM
No particular value other than reading pleasure. Not always accurate from a technical standpoint but tips and articles from rod builders in general. Some good tips and ideas. I believe they are still publishing in some form but infrequently. Re: Rod Crafters Journal
Posted by:
Henry Curtis
(216.40.249.---)
Date: October 03, 2003 09:03PM
Good little booklets. But as Ed said do not bank too heavily on anything of a technical nature you see in them. The ideas and tips are fine. Back issues are still selling for about 2 bucks apiece so I don't think you have anything very valuable unless you have some older copies that they're out of and someone might want. Put them up on @#$%& and see what they bring if you want to try and sell them. Re: Rod Crafters Journal
Posted by:
Dennis J. Danku
(---.proxy.aol.com)
Date: October 04, 2003 11:42AM
Rick, Check Mud Hole for the weaving tool. Dennis Re: Rod Crafters Journal
Posted by:
Wes Woods
(---.hsd1.mi.comcast.net)
Date: February 07, 2017 08:41PM
Hey Rick do you still have these? Sorry, only registered users may post in this forum.
|