SPONSORS
2024 ICRBE EXPO |
St.Croix Handle Question
Posted by:
BigAl
(---.tnt4.athens.ga.da.uu.net)
Date: December 12, 2001 08:37PM
This is the first time I have used a St. Croix Handle Kit. I am using a St. Croix 2c70MF blank with a CG-21 handle kit. The kit has a plug that goes in the end of the handle. Do I bring the blank all the way back to the end of the handle then trim back the plug to go inside the blank or do I leave enough room to just push the plug in and meet the blank about 1/4 inch for the end. Thanks Al Bassett Butt Plug
Posted by:
Richard's Rod & Reel Service
(---.voyageur.ca)
Date: December 12, 2001 09:03PM
Al, You can leave a little room at the back, say less than 1/4" between the blank butt and the edge of the rubberized cork end, dab some rod bond in there and push the plug in tight. Let is set and trim flush with a sharp blade and lightly sand after if necessary. Done this way will leave a nice clean finish. Rich Solyrich Custom Rods Sorry, only registered users may post in this forum.
|