SPONSORS
2024 ICRBE EXPO |
rod dryer
Posted by:
Jim Gaskins
(---.proxy.aol.com)
Date: December 07, 2001 09:52AM
I have just put together a makeshift rod dryer, and have one qestion.The rod doesn't turn 100% true it has a little bit of awobble to it will this have an effect onthe finish? It's only turning about 8rpm's.II know it would at at higher rpm's, but this is turning pretty slow. Thanks for any input Jim Gaskins Re: rod dryer
Posted by:
Tom Kirkman
(---.dialinx.net)
Date: December 07, 2001 10:03AM
Yes, depending on many other things as well this could impact how your finish turns out. I would want it as true as possible. Where is the "wobble" coming from? The chuck, or the support/s? ............ Sorry, only registered users may post in this forum.
|