SPONSORS
2025 ICRBE |
A new queston of labels
Posted by:
Dale Thompson
(---)
Date: October 26, 2024 12:57PM
I'm applying (DecalConnection) labels to the brass end caps on my fly rod tubes (2" diameter).Do I need to overcoat with epoxy? My past experience is that the epoxy dries wavy, I think because of the large diameter compared to a rod blank. Any tips on how to get a smooth essentially invisable epoxy layer over the label? Or a better way to do labels on the tubes? Re: A new queston of labels
Posted by:
Kerry Hansen
(---.wavecable.com)
Date: October 26, 2024 01:31PM
i THINK EPOXY WOULD NOT BE HARD ENOUGH SO i USE PERMA GLOSS OR SIMILAR EVA ONE PART FINISH. Sorry, only registered users may post in this forum.
|