SPONSORS
2025 ICRBE |
Handle assembly from the bottom...
Posted by:
Chris Catignani
(---)
Date: August 01, 2024 08:00PM
I recently came across a couple rods where I had to redo the handle assemblies from the bottom (with guides in palce).
I don't do this that often...but this time... I reamed out the polyurethane arbors (3) to the diameter of the blank in situ. Then I sliced the arbors longwise with a razor bland...applied epoxy, put on the blank and then wrapped tape around the arbors until they cured. The arbors were as if they were installed from the top. Edited 1 time(s). Last edit at 08/02/2024 12:10PM by Chris Catignani. Re: Handle assembly from the bottom...
Posted by:
Les Cline
(---)
Date: August 02, 2024 12:25PM
Great tip, Chris! Sorry, only registered users may post in this forum.
|