SPONSORS
2025 ICRBE |
Stress Testing Rod Blanks
Posted by:
Doug Noble
(152.37.241.---)
Date: June 27, 2024 07:35AM
What is the Proper way to "Stress Test" a rod blank prior to building on it? Re: Stress Testing Rod Blanks
Posted by:
Mike Ballard
(---.ip-54-39-133.net)
Date: June 27, 2024 08:13AM
Inspect and look at it closely. Flex it across its entire length and deeply enough to get some bend down into the blank's mid-section. Do NOT use your thumb and forefinger to apply the pressure. Grasp the butt and apply the pressure up top with the palm of your hand or press the tip down along the floor. If it is a multi-piece rod I would thread reinforce the ferrule before doing this. Re: Stress Testing Rod Blanks
Posted by:
Herb Ladenheim
(---.cdn77.com)
Date: June 27, 2024 11:20AM
YES
Herb CTS Sorry, only registered users may post in this forum.
|