SPONSORS
2024 ICRBE EXPO |
Re: guide foot adhesive
Posted by:
Phil Erickson
(---)
Date: January 01, 2023 03:16PM
I have used he guide foot adhesive on both the Eterrnity2 and the PB guides without any problems.
There is learning curve in using the adhesive! Heat the guide and then wipe the foot across the adhesive. Try testing this first by checking to see if you are getting adhezive onto the foot. Re: guide foot adhesive
Posted by:
david taylor
(---)
Date: January 01, 2023 06:39PM
Thanks. Ah, I must be behind on the learning curve. I will give it another try as I prepare to build out a new NFC LMX 9 ft. 5wt fly rod. I find taping a bit tedious. Re: guide foot adhesive
Posted by:
david taylor
(---)
Date: January 01, 2023 09:02PM
Thanks. Ah, I must be behind on the learning curve. I will give it another try as I prepare to build out a new NFC LMX 9 ft. 5wt fly rod. I find taping a bit tedious. Re: guide foot adhesive
Posted by:
roger wilson
(---)
Date: January 01, 2023 09:22PM
Michael,
I doubt it very much- with respect to using tape to secure guides. Re: guide foot adhesive
Posted by:
Tom Wewerka
(---)
Date: January 03, 2023 10:16AM
David
The adhesive dries rather quickly. Sometimes after I run the foot across the glue stick I'll reheat the foot again lightly before applying it. I've never had a problem with it sticking............good luck. Tom Sorry, only registered users may post in this forum.
|