SPONSORS
2024 ICRBE EXPO |
Offset casting handles
Posted by:
Ron Schneider
(---.mid.dyn.suddenlink.net)
Date: November 23, 2022 09:07AM
Here is link to the "offset" casting reel seats and grips,
they are a complete assembly and attach by gluing the blank into the end of the handle assembly. [www.schneidersrods.com] They are new old stock. Best wishes, Ron Schneider Schneider's Rod Shop Mountain Home, Arkansas [www.schneidersrods.com] mtnron40@yahoo.com 870-424-3381 Re: Offset casting handles
Posted by:
El Bolinger
(---.bstnma.fios.verizon.net)
Date: November 25, 2022 07:47AM
To fit a blank the blank butt must be exactly .5?
Any size 20 Butt cap will fit from any brand? Re: Offset casting handles
Posted by:
Spencer Phipps
(---)
Date: November 25, 2022 01:00PM
You build up the end of the blank if it's smaller than 1/2 inch, if the depth of your 20 mm butt cap is short for the provided tenon on the back of the grip, you just shorten the tenon a bit, so yes, any 20 mm butt cap will fit. Myself I prefer blank through construction, but to each your ow, I can see a way to extending a rod's length a bit with this system. Re: Offset casting handles
Posted by:
El Bolinger
(---.bstnma.fios.verizon.net)
Date: November 26, 2022 09:52AM
Do you mean there's a way to attach that to a blank all the way through from front to back? Sorry, only registered users may post in this forum.
|