SPONSORS
2024 ICRBE EXPO |
Re: Static testing fly blank
Posted by:
Phil Ewanicki
(---.res.spectrum.com)
Date: July 07, 2022 11:12AM
"Just want to load the rod to make sure it doesn't break." Rods don't break at the ferrule, so just bending each section separately between right and and left hand will do the specified job. No need to build or buy specialized equipment, take exacting measurements, or apply advanced mathematics. Re: Static testing fly blank
Posted by:
Marc Calabrese
(198.160.5.---)
Date: July 07, 2022 12:50PM
I thought that flexing each section separately to test would be a bad idea, as the rod was designed to distribute the flex and load along the whole length of the rod not individual sections but I am probably over thinking this. Re: Static testing fly blank
Posted by:
Mark Talmo
(---)
Date: July 07, 2022 05:26PM
Marc,
You are NOT over-thinking it and are correct. But there are others who could benefit from thinking more. Mark Talmo FISHING IS NOT AN ESCAPE FROM LIFE BUT RATHER A DEEPER IMMERSION INTO IT!!! BUILDING YOUR OWN SIMPLY ENHANCES THE EXPERIENCE. Re: Static testing fly blank
Posted by:
Phil Ewanicki
(---.res.spectrum.com)
Date: July 09, 2022 04:48PM
No matter how much a rod bends or where a rod bends or the rod's recovery rate one fact remains the same: the rod can only pull a line, not push it. Re: Static testing fly blank
Posted by:
Mark Talmo
(---)
Date: July 09, 2022 07:06PM
Phil,
You have stated the obvious = what’s your point? Furthermore, what does that have to do with this post anyway? Mark Talmo FISHING IS NOT AN ESCAPE FROM LIFE BUT RATHER A DEEPER IMMERSION INTO IT!!! BUILDING YOUR OWN SIMPLY ENHANCES THE EXPERIENCE. Re: Static testing fly blank
Posted by:
ben belote
(---.hsd1.md.comcast.net)
Date: July 10, 2022 09:30AM
Phil, I know how to use a rod to push a line. Edited 1 time(s). Last edit at 07/10/2022 10:41AM by ben belote. Re: Static testing fly blank
Posted by:
ben belote
(---.hsd1.md.comcast.net)
Date: July 10, 2022 09:31AM
Phil, I know how to use a rod to push my push on a line. Re: Static testing fly blank
Posted by:
Phil Ewanicki
(---.res.spectrum.com)
Date: July 10, 2022 10:15AM
Lefty K. coud cast a full fly line with his bare hands. So what? So you can't spend enough money on rods or lines to make you a proficient fly-caster. "It's a poor workman who blames his tools." - and a frustrated fly caster who expects he can buy equipment which will make him a competent fly caster. Re: Static testing fly blank
Posted by:
ben belote
(---.hsd1.md.comcast.net)
Date: July 10, 2022 11:34AM
It,s really quite easy. Sorry, only registered users may post in this forum.
|