SPONSORS
2024 ICRBE EXPO |
NFC CF butt cap options
Posted by:
Darwin Wong
(---.cpe.net.cable.rogers.com)
Date: September 02, 2021 11:37AM
Have a 14” nfc carbon fibre grip shipping. Was going to pick up a butt cap and maybe trim ring from mud hole but not quite sure the size I should get. Anyone have some experience with them? Do they have similar dimensions to the CFX brand or another brand I can interchange the parts?
[northforkcomposites.com] Thanks! Re: NFC CF butt cap options
Posted by:
Norman Miller
(---)
Date: September 02, 2021 11:59AM
I have not used the 14” NFC CF grip, but of the NFC CF grips I have used the dimensions are almost identical to those of the CFX grips. So you should have no problems using the same butt caps you used on the CFX grips.
Norm Re: NFC CF butt cap options
Posted by:
Spencer Phipps
(---)
Date: September 02, 2021 01:01PM
They are 27 mm like a casting cork grip if this helps, both ends. You will have to figure out an arbor though if the option you want isn't one also, the EVA butt cap on the NFC grip is also the arbor, you could always cut the tenon off and use it as an arbor if the new butt cap needs one. Edited 2 time(s). Last edit at 09/02/2021 01:07PM by Spencer Phipps. Re: NFC CF butt cap options
Posted by:
Darwin Wong
(---.cpe.net.cable.rogers.com)
Date: September 03, 2021 02:04AM
Thanks Norman and Spencer
Sounds like i'll probably be ok or can make it work with some slight modifications. Sorry, only registered users may post in this forum.
|