Bob,
Yes, of course, this is a very easy task to complete.
Simply use a double pole double throw switch of your choice, cross wire it, hook it into the wiring between the controller and the motor and you will be good to go.
For example:
[
www.amazon.com]
or:
[
www.amazon.com]
Or any other 6 contact double pole double throw switch of your choice.
Then, cross wire it:
Here is the schematic diagram to wire the switch:
[
rollertrol.com]
Basically connect the motor controller wires to the center terminals on the switch ( + and - wires).
Then, take a pair of wires and form an X from the front two terminals to the back two terminals.
Then, connect the motor to either end of the two switch contacts on one end of the switch and you will be set.
If you like, you could just drill a hole in the base of the dryer to mount a toggle switch and then do the wiring from the controller to switch to the motor.
Should only be about a 15 minute job.
Best wishes
p.s.
If you like, you can purchase this switch:
[
www.amazon.com]
This switch already has the X wiring installed so you only have to put dc power on the center set of terminals and the motor on the other set of terminals.
