SPONSORS
2024 ICRBE EXPO |
underwrap
Posted by:
Don Baker
(---.ksca.qwest.net)
Date: November 30, 2020 11:53AM
I'm rebuilding some catfish rods and want to underwrap the guides. If I use Permagloss on the underwrap how long do I need to wait to wrap guides and finish with flexcoat? Re: underwrap
Posted by:
Tom Kirkman
(Moderator)
Date: November 30, 2020 11:54AM
I'd wait at least 3 full days.
............ Re: underwrap
Posted by:
Mark Talmo
(---)
Date: November 30, 2020 02:20PM
Don,
What advantage are you seeking or expecting by using both PG and flexCoat as well? By using the same material (either PG or FlexCoat) for both the under and over wraps, you should be able to apply the over wrap and finish in 24 hours. PG is a moisture-curing urethane and requires exposure to the humidity in the air to cure; hence, as Tom stated, waiting 3 days would be advised if sealed-off by the FlexCoat. On the other hand, two-part catalyzed epoxies will cure within themselves whether or not sealed-off from the air.. Mark Talmo FISHING IS NOT AN ESCAPE FROM LIFE BUT RATHER A DEEPER IMMERSION INTO IT!!! BUILDING YOUR OWN SIMPLY ENHANCES THE EXPERIENCE. Re: underwrap
Posted by:
ben belote
(---.zoominternet.net)
Date: November 30, 2020 02:47PM
In the old days we used CP and before that laquer..lol. Sorry, only registered users may post in this forum.
|