SPONSORS
2024 ICRBE EXPO |
Butt Cap Installation
Posted by:
Larry Berkovsky
(---.kngwcmtk03.res.dyn.suddenlink.net)
Date: November 23, 2020 12:07PM
Gents, a quick question…..instead of cutting a tenon on the handle butt each time on a lathe, is there another way of attaching a butt cap to the end of a custom made casting grip. I prefer the #2 EVA/Cork butt caps that Mudhole sells. Been experimenting with short extensions out of the blank but the hassle factor is a little high.
Thanks in advance. Berk Re: Butt Cap Installation
Posted by:
Norman Miller
(---)
Date: November 23, 2020 12:21PM
Try a piece of 20 mm polyurethane foam arbor. This size will fit most butt caps, and it is very easy to ream and sand.
Norm Re: Butt Cap Installation
Posted by:
Larry Berkovsky
(---.kngwcmtk03.res.dyn.suddenlink.net)
Date: November 23, 2020 04:52PM
Heck Norm. I think that’s it! Thanks Sorry, only registered users may post in this forum.
|