SPONSORS
2024 ICRBE EXPO |
ACS vs ECS Casting Seat
Posted by:
Rick Shaffer
(69.77.100.---)
Date: August 19, 2020 10:02AM
I have built using Fuji ECS, have not done a custom build using the Fuji ACS...anyone have any comments?? Are there any differences good or bad? Thank you in advance. Re: ACS vs ECS Casting Seat
Posted by:
benjie bates
(---.hfc.comcastbusiness.net)
Date: August 19, 2020 10:12AM
i would get one and try it out and find out for yourself Re: ACS vs ECS Casting Seat
Posted by:
Norman Miller
(---)
Date: August 19, 2020 10:35AM
Both are excellent exposed blank reel seats. The ACS has an extra finger groove and is really good for people who like to palm their reel, i.e., three or four fingers in front of the trigger. For both, the ID are sized to fit the blank. For the ACS this sizing is throughout the length of the seat, and for the ECSM it is sized only in the rear half, I usually arbor the front half before installing. Just a matter of preference.
Norm Re: ACS vs ECS Casting Seat
Posted by:
Lynn Behler
(---.97.252.156.res-cmts.leh.ptd.net)
Date: August 19, 2020 07:11PM
Boy, I'm glad I read this , I thought both were cored the same way. I only used the ACS in the past. was just about to order an ECS, but without any of the necessary arbor material. Thanks again Norm! Sorry, only registered users may post in this forum.
|