SPONSORS
2024 ICRBE EXPO |
Arbor for the Unified Wheel
Posted by:
Steve Emmert
(---.dsl.sntc01.pacbell.net)
Date: November 25, 2001 11:24AM
What kind of arbor is everybody using with these wheels? ---Steve Re: Arbor for the Unified Wheel
Posted by:
Tom Kirkman
(---.dialinx.net)
Date: November 25, 2001 11:36AM
Go to your local hardware store and just get a small arbor of the appropriate size. They should have them and usually they are only about $2 or so. ............ The poor man's version
Posted by:
Mike B.
(---.proxy.aol.com)
Date: November 25, 2001 08:06PM
For what it's worth you can make your own from a bolt. Take a bolt that fits through the wheel center and drop a washer on it. slide the wheel on it. Now take another washer and put that on and then a nut. Tighten the nut on the wheel. Put a couple winds of masking tape on the end of the bolt and chuck in your drill or lathe chuck. That's all there is to it. Instant arbor! Sorry, only registered users may post in this forum.
|