SPONSORS
2024 ICRBE EXPO |
Butt Question ha, ha,ha
Posted by:
David Hartman
(216.75.200.---)
Date: July 06, 2020 02:09PM
I an looking at a rod with a 0.790 butt size.
Where or what company can I get a cork handle for this? Thank you, Re: Butt Question ha, ha,ha
Posted by:
Spencer Phipps
(---)
Date: July 06, 2020 02:20PM
Anglers Workshop has an oversized 1.35" I believe 12 inch long rear cork grip the butt cap that goes with it is 1 1/2 to 2 inches deep. Been a long time since I used one so it's all mind's eye info. Re: Butt Question ha, ha,ha
Posted by:
Spencer Phipps
(---)
Date: July 06, 2020 02:20PM
Anglers Workshop has an oversized 1.35" I believe 12 inch long rear cork grip the butt cap that goes with it is 1 1/2 to 2 inches deep. Been a long time since I used one so it's all mind's eye info. Re: Butt Question ha, ha,ha
Posted by:
David Hartman
(216.75.200.---)
Date: July 06, 2020 03:28PM
Thanks Re: Butt Question ha, ha,ha
Posted by:
Norman Miller
(---)
Date: July 06, 2020 03:44PM
You could use a reverse pilot bit to enlarge the ID of a grip, and then ream with a large diameter reamer to get the final fit.
[www.therodroom.com] Norm Re: Butt Question ha, ha,ha
Posted by:
Spencer Phipps
(---)
Date: July 06, 2020 04:01PM
The grip comes with a larger than normal hole, was designed for larger OD blanks and larger reel seats. Re: Butt Question ha, ha,ha
Posted by:
Brian Gross
(50.226.78.---)
Date: July 07, 2020 10:12AM
I have some 1.25" x 6" straight cork you can glue 2 together to get a 12" or longer handle. Sorry, only registered users may post in this forum.
|