SPONSORS
2024 ICRBE EXPO |
NFC EFX grip winding checks?
Posted by:
Jason Haney
(---.mountainresearch.com)
Date: February 28, 2020 07:12AM
NFC blanks showed up the other day and I bought two of their new EFX grips to go with them. I've got a huge gap (maybe 1/8") between the blank and the ID of the grips. The only winding checks I have are too small, and do not completely fill the gap. I can fill it with epoxy and it'll be functional, but it'll look like @#$%&. Has anyone built with the EFX grips yet? What'd you use for winding check? Re: NFC EFX grip winding checks?
Posted by:
roger wilson
(---)
Date: February 28, 2020 09:29AM
Here is a variety of winding checks.
[www.mudhole.com] Perhaps something like this one: [www.mudhole.com] Or something like this one: [www.mudhole.com] Use a razor to slice off a section that will be the correct size for your situation. Perhaps one of these would fill the void? [www.mudhole.com] Or, one of these used intact or use a section of one of them: [www.mudhole.com] If appropriate, one of these winding checks from Alps might be the ticket for you: [alpsforecast.com] Perhaps one of these winding checks will work for you? [www.jannsnetcraft.com] Re: NFC EFX grip winding checks?
Posted by:
Lance Schreckenbach
(---.lightspeed.hstntx.sbcglobal.net)
Date: February 28, 2020 12:37PM
It would be pretty easy to turn some EVA foam for the purpose of the fill ends / winding checks. Re: NFC EFX grip winding checks?
Posted by:
Jason Haney
(---.pitbpa.east.verizon.net)
Date: February 29, 2020 09:06AM
Much appreciated, Lance and Roger! I'm going to snag a couple of size 17 vinyl winding checks and some EVA foam just in case. Re: NFC EFX grip winding checks?
Posted by:
Spencer Phipps
(---)
Date: March 01, 2020 02:31PM
When they are not using their own reelseats, etc., they seem to be drawn to Batson products. Re: NFC EFX grip winding checks?
Posted by:
Karl Witherow
(---.28.188.173.dynamic.ip.windstream.net)
Date: March 01, 2020 08:26PM
I spoke with a fella at American Tackle the other day about the add that was in RodMaker magazines last issue. The advertisement showed winding check and a transition piece for the rear grip to reel seats for their G2 seats and carbon fiber grips. He said the add was pre-mature but they were suppose to ship those items to distributors this week. I have purchased some of the NFX carbon (soft touch) grips and I think these winding checks and transition piece will be just the ticket. If anyone has seen or can get these new items, I would like to hear from you. Sorry, only registered users may post in this forum.
|