SPONSORS
2024 ICRBE EXPO |
Large bubble in Flexcoat syringe
Posted by:
William Giokas
(---)
Date: February 22, 2020 05:51AM
How do you get a rather large bubble out of a pre loaded syringe of Flexcoat? My Flexcoat syringe has a large bubble and I wonder how to get it out before I apply it to the rod wraps . The bubble is in the Resin syringe.
Thanks in advance. Bill Re: Large bubble in Flexcoat syringe
Posted by:
Ross Pearson
(---.dlth.qwest.net)
Date: February 22, 2020 08:15AM
Hold the syringe vertical with the nozzle up and the bubble should float up to the opening where you can push it out with a little pressure on the plunger. You may have to adjust the volumes if they are not equal in both syringes. Re: Large bubble in Flexcoat syringe
Posted by:
John DeMartini
(---.res.bhn.net)
Date: February 22, 2020 10:29AM
Ross', suggestion is spot on.
I would set the syringe vertical and place it in a warm area, it may take time for the bubble to float to the top. John Sorry, only registered users may post in this forum.
|