SPONSORS
2024 ICRBE EXPO |
WEAVE
Posted by:
Jeffrey D Rennert
(---)
Date: November 22, 2019 08:04AM
Has anyone tried weaving over thread work? Thank you. It's not easy being me at times. Re: WEAVE
Posted by:
Ken Brown 2
(---.229.194.3.res-cmts.sm.ptd.net)
Date: November 22, 2019 08:11AM
I have not. I would assume many replies here. My thought would be to have your base thread work laid down. Then add a thin layer of epoxy or CP. After that application is cured, then add your weave. This will help prevent any slippage of the weave into the base thread work. Re: WEAVE
Posted by:
Jim Upton
(---)
Date: November 22, 2019 12:27PM
Yes, Just finish the under work first. Remember to try and center the weave on the pattern of the under work so it looks balanced when finished. Re: WEAVE
Posted by:
Jim Upton
(---)
Date: November 22, 2019 12:27PM
Yes, Just finish the under work first. Remember to try and center the weave on the pattern of the under work so it looks balanced when finished. Sorry, only registered users may post in this forum.
|