SPONSORS
2024 ICRBE EXPO |
Grey EVA grips
Posted by:
Shane Jarvis
(161.7.159.---)
Date: May 21, 2019 02:05PM
Does anyone have a source for grey EVA grips? I searched the topic and didn't get the results I was looking for. I don't not have the capability to turn my own right now. Re: Grey EVA grips
Posted by:
Robert A. Guist
(---.triad.rr.com)
Date: May 21, 2019 02:20PM
Hello Shane.
Check with MudHole on the left list of sponsors. Tight Wraps & Tighter Lines. Bob, New Bern, NC. Re: Grey EVA grips
Posted by:
Billy Vivona
(---.nycmny.fios.verizon.net)
Date: May 21, 2019 05:18PM
what size are you looking for? ID? Re: Grey EVA grips
Posted by:
Brook Oliva
(---.se.biz.rr.com)
Date: May 21, 2019 05:56PM
18" Unshaped Grips in 3 ID's, Available in Grey, Grey Grain, and Grey Urban Camo: [www.mudhole.com]
Also available in EVA Block: [www.mudhole.com] Kind Regards, Brook Oliva Mud Hole Custom Tackle, Inc. brook@mudhole.com (866)-790-RODS Re: Grey EVA grips
Posted by:
Shane Jarvis
(161.7.159.---)
Date: May 22, 2019 10:03AM
I guess I should have been a little more specific. I would like a pre-made split grip with a 3/8 inch inside diameter.
I don't have a lathe to turn my, how hard would it be shape the round EVA with out a lathe? Re: Grey EVA grips
Posted by:
Tom Kirkman
(Moderator)
Date: May 22, 2019 11:43AM
You can make an impromptu lathe from a drill and a V-stand. Check the photo page under tools and see what turns up. This sort of set-up is usually good enough for occasionally shaping of small EVA pieces.
............. Re: Grey EVA grips
Posted by:
Shane Jarvis
(161.7.159.---)
Date: May 22, 2019 12:02PM
Tom Kirkman Wrote:
------------------------------------------------------- > You can make an impromptu lathe from a drill and a > V-stand. Check the photo page under tools and see > what turns up. This sort of set-up is usually good > enough for occasionally shaping of small EVA > pieces. > > ............. Thanks, I think I will give that a try Re: Grey EVA grips
Posted by:
Spencer Phipps
(---.hsd1.or.comcast.net)
Date: May 23, 2019 07:00PM
You do have the capability to make your own. Break out your 3/8 drill, install your 3/8 drill bit, slip on the grip, fire up the drill and shape the EVA to your liking with sandpaper, maybe 5 minutes per piece. Sorry, only registered users may post in this forum.
|