SPONSORS
2024 ICRBE EXPO |
factory rod blanks finish
Posted by:
Travis Thompson
(---.hsd1.il.comcast.net)
Date: February 09, 2019 03:21PM
Any of you guys know what type of finish the blank factories use after they sand the blanks? And for matte finish? Do any of them use piwder coating? Re: factory rod blanks finish
Posted by:
herb canter
(---.atmc.net)
Date: February 09, 2019 03:30PM
Most use automotive type paints , my guess is some type enamel . Not sure about the matte finishes though . Re: factory rod blanks finish
Posted by:
Tom Kirkman
(Moderator)
Date: February 09, 2019 06:02PM
There have been and are lots of types used, from squeegee coated epoxy paints, to automotive type urethanes and enamels. Different companies use different paints/finishes. There isn't really one industry-wide standard for blank coating.
............... Re: factory rod blanks finish
Posted by:
Travis Thompson
(---.hsd1.il.comcast.net)
Date: February 14, 2019 07:57PM
Thank you all very much! Sorry, only registered users may post in this forum.
|