SPONSORS
2024 ICRBE EXPO |
apply foam grips
Posted by:
darrel odland
(---.lightspeed.frokca.sbcglobal.net)
Date: January 19, 2019 03:18PM
Need some advice on installing a foam grip that has a smaller ID then OD of rod butt. I tried to ream it out, but was not very successful. Also what is difference between EVA, Hypalon and just plain foam ???
"Bent Rods to ya" Darrel Re: apply foam grips
Posted by:
Tom Kirkman
(Moderator)
Date: January 19, 2019 05:09PM
Check the online FAQs page here for instructions on how to install foam grips. You can find the actual differences in the various types of foam grips in the online Glossary here. Lots of resources on this forum if you poke around just a bit.
............. Sorry, only registered users may post in this forum.
|