I am hoping someone can direct me to a site that sells circular clamps to glue up cork rings

Are you talking about making rings from pie cut segments? Plastic wire ties work for that.

I have used the ties for years, but several months ago I purchased some circular clamps, but only purchased a dozen. I want to get some more of them, but can't remember the supplier. Which is why I am seeking out other rod builders.
Thanks for the reply

Thom Cherry
Louisville, KY

PVC rings, split down one side and sized slightly smaller than the rings, functions well for such clamps.

.........

I would think that a hose clamp would work very well.

[www.zoro.com]

Just order the size clamp that would work for you.

check out the clamps that JOE has on CUSTOM FLY GRIPS, they work great.

[customflygrips.com]

............. Sorry

William Sidney
AK



Edited 1 time(s). Last edit at 01/03/2019 12:34PM by Bill Sidney.

......................... Sorry

William Sidney
AK



Edited 1 time(s). Last edit at 01/03/2019 12:35PM by Bill Sidney.

,,,,,,,,,,,,,,,,,,,,,,, SORRY

William Sidney
AK

NOTE there is a tool that will make wire ties tight it is sold at most electronic supply stores , a little costly , but not bad, I did not check Amazon or E bay , but it will make the tie wraps tight an take all the
spaces out if the cork wedges , if you put a plastic shim in the center to help keep the ring of proper alinement a little smaller than 1/4 inch because of cutting loss cause by the with of the saw blade ,
I got my shim's from LOWE's , any plastic rod will work for the shim [ I think ] [PLASTIC ROD Tightbond will not stick to it ] ,

William Sidney
AK



Edited 1 time(s). Last edit at 01/03/2019 12:38PM by Bill Sidney.

Barry Weaver Wrote:
-------------------------------------------------------
> check out the clamps that JOE has on CUSTOM FLY
> GRIPS, they work great.

Can these be reused? They look like they would work great and zip ties are single use only.

res they can be reused.