SPONSORS
2024 ICRBE EXPO |
2nd coat
Posted by:
Chris McGregor
(---.dsl.lgvwtx.sbcglobal.net)
Date: December 23, 2018 04:33PM
Newbie
I recently started building rods, still learning. My question is, can I use a different epoxy for my 2nd coat? (1st coat is prokote and I ran out, but I have flex coat) Can I put flex coat on top of prokote, if so, is there any special precautions or prep? 1st coat was applied over a week ago. Thanks Re: 2nd coat
Posted by:
Lynn Behler
(---.97.252.156.res-cmts.leh.ptd.net)
Date: December 23, 2018 05:18PM
Should not be any problem. I would lightly scuff the first coat with scotchbrite before applying second. Re: 2nd coat
Posted by:
John DeMartini
(---.res.spectrum.com)
Date: December 23, 2018 06:50PM
Chris
Yes you can. Make sure you prepare the surface, if not sure follow the manufacturers recommendations. Have fun John Re: 2nd coat
Posted by:
Chris McGregor
(---.dsl.lgvwtx.sbcglobal.net)
Date: December 23, 2018 08:30PM
Thank you both Sorry, only registered users may post in this forum.
|