SPONSORS
2024 ICRBE EXPO |
Fuji Perfect Fit question
Posted by:
David DeBruhl
(---.dhcp.gnvl.sc.charter.com)
Date: December 01, 2018 07:34AM
I am building a rod for a customer who wanted the Fuji PF handle assembly. I ordered all of the specific trim rings noted on the Anglers resource site and even talked to the customer support when I ordered. There just seems to be something missing where the cap ring on the carbon fiber hidden sleeve goes. I ordered the 24-12 size which the 12 mm is the inside diameter. The blank at this point is 10.2 mm, so there is more space than I like. It also does not look finished, like something is missing. I have tried and spoken with customer service from two separate supply houses and both tell me that is all the components listed for this assembly. Any ideas guys. Re: Fuji Perfect Fit question
Posted by:
Spencer Phipps
(---.hsd1.or.comcast.net)
Date: December 01, 2018 09:00PM
is this measurement taken before or after thread and finish? Re: Fuji Perfect Fit question
Posted by:
David DeBruhl
(---.dhcp.gnvl.sc.charter.com)
Date: December 01, 2018 10:06PM
Before. I received a PM that the piece that I need is CREVA but most suppliers only carry the CREVD which is dual color. I am going to call the Rod Room and see if they can help. Re: Fuji Perfect Fit question
Posted by:
Jim Ising
(---.dyn.centurytel.net)
Date: December 03, 2018 10:27AM
David if you can send a phone pic I'll try to spec what you need. Send to info@anglersresource.net. If you have a hard carbon sleeve you do not need CREVA.
Jim Re: Fuji Perfect Fit question
Posted by:
David DeBruhl
(170.7.248.---)
Date: December 03, 2018 02:31PM
Jim. This is on a hard carbon sleeve.I will send a pic this evening when I get home from work. Sorry, only registered users may post in this forum.
|