SPONSORS
2024 ICRBE EXPO |
part# for rod lathe belt
Posted by:
John Samuels
(---.hsd1.va.comcast.net)
Date: September 18, 2018 09:21AM
Can anyone give me the part# off the Gates notched v-belt that came with the Renzetti rod lathe? Re: part# for rod lathe belt
Posted by:
Doug Cox
(---.rtmc.net)
Date: September 18, 2018 10:52AM
Gates #3M315 Re: part# for rod lathe belt
Posted by:
John Ricks
(---.tukw.qwest.net)
Date: September 18, 2018 11:21AM
Buy two then you will have a spare.
A lesson learned in my machine shop. Spare belts for each piece of machinery. And write the belt number on the machine somewhere!!!! I put the belt numbers inside the belt cover. Re: part# for rod lathe belt
Posted by:
roger wilson
(---)
Date: September 18, 2018 12:21PM
[www.cnczone.com]
[www.vbeltsupply.com] [vbeltsdirect.com] [www.taigtools.com] [www.royalsupply.com] -------------- With any item source, be sure to check for the shipping charges to get your total item cost. If sourcing something that is harder to find, you can often order multiples of the item with no change in shipping charges, if there are any such charges. Good luck Re: part# for rod lathe belt
Posted by:
John Samuels
(---.hsd1.va.comcast.net)
Date: September 18, 2018 12:47PM
Thanks everyone ... extras ordered ... # written on Lathe. Re: part# for rod lathe belt
Posted by:
roger wilson
(---)
Date: September 25, 2018 12:46PM
p.s.
The Gates specification for the #3m315 belt is: 1/8th top width - v belt Length = 12. 4 inches. However, note that 12.4 inches = 315mm. Thus, the Gates specification listing indicates the length of the belt in MM. The gates listing specification also indicates the width of the top of the belt in MM. i.e. 3M indicates a top width of 3 milimeters which is also equal to 1/8 of an inch. 315 indicates the belt length of 315 millimeters or 12.4 inches. So, keep an english to metric conversion table handy and you can quickly visualize the listings on the belt. Good luck Sorry, only registered users may post in this forum.
|