SPONSORS
2024 ICRBE EXPO |
Re: CCS on the Fenwick
Posted by:
Anthony Unger
(---.44.102.191.res-cmts.ovr.ptd.net)
Date: September 06, 2018 12:08PM
Thats hard for a machinist to hear lol.. I have to remember the fish dont care... Re: CCS on the Fenwick
Posted by:
Spencer Phipps
(---)
Date: September 08, 2018 11:31AM
Even with the small differences between a bare vs finished blank, you're way ahead of the rod shakers and tip benders on the floor, or ceiling.
That other system I've seen on some of the bass forums, seems half baked compared to the the CC system. Lots of info not avilable when I tried it, lot's of "what about this" questions I asked were anwered by churping crickets. Re: CCS on the Fenwick
Posted by:
Anthony Unger
(---.s665.c3-0.atw-cbr1.atw.pa.cable.rcncustomer.com)
Date: September 08, 2018 11:48AM
This forum is as knowledgeable to rod building as fly anglers online (faol) is to fly tying.. Im proud, and honored to be a member of both..
Thanks for the cofidence boost.. Lol as i read the churping crickets, i hear one goin to town outside my truck.. Lol how convenient Sorry, only registered users may post in this forum.
|