SPONSORS
2024 ICRBE EXPO |
New wrapper
Posted by:
Lee Semon
(---.hsd1.tn.comcast.net)
Date: July 24, 2018 05:53PM
I have it about 99% built. Just not sure how I want to set up the thread tensioner.
That said How do I post a Picture? Re: New wrapper
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: July 25, 2018 12:24PM
Lee,
Good pictures. Also wonderful work on your upholstery. I see that you are using lined V=blocks to hold your rod. On each side of the v-block, there is a black strap. Is it your design to use the black strap over the rod and velcroed on the other side of the v-block to hold the blank down to the bottom of the V-block?? Take care Roger Re: New wrapper
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: July 25, 2018 12:48PM
Lee,
I found your pictures, copied and edited them and then uploaded them to the Rodbuiding.org photo pages under equipment as follows: [www.rodbuilding.org] [www.rodbuilding.org] [www.rodbuilding.org] [www.rodbuilding.org] Nice job that should work very well to build a bunch of rods. I assume that you will be adding an extension, if you plan to build any rods other than multi piece rods? Take care Roger Re: New wrapper
Posted by:
Lee Semon
(---.hsd1.tn.comcast.net)
Date: July 25, 2018 04:15PM
Pict. shows a V block that stands off the wrapper that is the same height as the ones on the wrapper just move past the end but then you would need a long place to put it.
The wrapper is 4ft long and the black straps are velcro with a piece of white on the other side of the V. If I ever need an extension for it, it would have an adjustable leg to hold the other end. Thanks for bringing the pictures over here. Re: New wrapper
Posted by:
roger wilson
(---.hsd1.mn.comcast.net)
Date: July 25, 2018 05:30PM
--------------------- Edited 2 time(s). Last edit at 07/25/2018 06:46PM by roger wilson. Re: New wrapper
Posted by:
herb canter
(---.s5.ans1.ns148.ztomy.com)
Date: July 25, 2018 08:18PM
Wow, fantastic job , very well done . Sorry, only registered users may post in this forum.
|